Connections
R5975809 BARCO CINE 6 ___________________________________________________________________________________
3-1
3
CONNECTIONS
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
on the rear of the projector.
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed
: ON
Not pressed
: OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand by mode', depending on the software
setting in the service menu of the projector . This is done during installation by a qualified technician. If you want to change
this start up mode, call a qualified technician.
Stand by indication lamp :
No light up
:
Projector in operational mode
Red
:
Projector is in stand by.
Leds on the rear plate of the projector
Signal input connection to the projector :
- Composite Video
- S-Video
- RGB
- YUV (component input)
Note : All sync types accepted and Muse HDTV Standard accepted.
* Input signal Y/C (luma/chroma)
On RGB/YUV/Gs/H,V sep /Gs /CS on both Pol accepted
Connecting a Composite Video source
Composite video signals from a VCR, OFF air signal, decoder, etc.
1234
1234
1234
1234
TV Tuner
VCR
Audio
Amplifier
Composite
Video
STDBY / NORMAL
PAUSE
COINCIDENCE
EHT HOLDOWN
IR RECVD
Source No Projector input
Press digit
1
Comp. Video
1
2
S-Video*
2
3
RGB/15K/32K
3
4
HDTV(Gs)
4
Muse
5
YUV
5
6
YUV on HDTV
6
Summary of Contents for R9002370
Page 1: ...R9002370 R9002379 OWNER S MANUAL CINE 6...
Page 2: ......