4-3
Connections
5976183 BARCOGRAPHICS 6500 31012001
Switching Off
To switch off:
- First press
STANDBY
key for 2 seconds. When the message 'Saving data, please wait' is displayed, do not press any longer on
the standby key otherwise the projector will restart. Let cool down the projector at least 10 min.
- Switch off the projector with the power switch.
Switching to Stand-by Warning
When switching to standby, it is possible to restart within the first 5sec.. When not restarted within these first 5 sec.,
the projector waits for 1 min. to restart again. During this period the LED display will show a jumping square with a dash.
After one minute, two dashes will be displayed and the projector can restart.
Input Source Connection
Input facilities
5-cable input
Computer
Video
S-Video
Serial digital input
IEEE 1394 (optional)
Input Selection
This can be manually or automatically.
When 'automatic' is selected in the Input slots menu, by starting up the projector, it searches for an input source by scanning the
inputs one by one. If only one source is found, this source will be projected. If different sources are found, the priority is as follow:
1. Video
2. S-Video
3. 5 Cable input
4. Computer input
SDI input and IEEE input are never automatically selected.
Note : When a RCVDS is connected to the projector,
the 'Automatic' selection is disabled.
Set up of the input selection
1 Press
ENTER
to start up the adjustment mode.
2 Press the cursor key
é
or
ê
to select 'Installation' (menu 1).
3 Press
ENTER
to display the Installation menu.
4 Press the cursor key
é
or
ê
to select 'Input Slots' (menu 2).
5 Press
ENTER
to display the Input slots menu.
6 Press the cursor key
é
or
ê
to select 'Input Slots' (menu 3).
7 Press
ENTER
to toggle between [Manual] or [Automatic].
8 Press
EXIT
several times to leave the adjustment mode.
Select with
ê
or
é
then <ENTER>
<EXIT> to return.
Select with
ê
or
é
then <ENTER>
<EXIT> to return.
INSTALLATION
INPUT SLOTS
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
INPUT SLOTS
SLOT SELECTOR [Automatic]
x 1. RGB [HS&VS]
- 2. RGB [HS&VS]
- 3. VIDEO
- 4. S-VIDEO
- 5. DIGITAL INPUT
- 6. IEEE 1394
Select with
ê
or
é
<ENTER> to toggle
<EXIT> to return.
menu 1
menu 2
menu 3
Input Facilities, RCVDS05 connected.
When using a RCVDS05, it is recommended to use a 5-cable output module in the RCVDS. The outputs of this module have to be
connected to the 5 cable input (slot 1) of the projector.
To switch the projector in the 5-cable mode see chapter 'Installation mode'.
Summary of Contents for R9001950
Page 28: ...4 12 Connections 5976183 BARCOGRAPHICS 6500 31012001...
Page 62: ...8 22 Random Access Adjustment Mode 5976183 BARCOGRAPHICS 6500 31012001...
Page 72: ...9 10 Installation Mode 5976183 BARCOGRAPHICS 6500 31012001...
Page 102: ...D 2 Cleaning the Dustfilter 5976183 BARCOGRAPHICS 6500 31012001...