Power Connections
3-2
5975958 RETRO GRAPHICS 2100 210198
Projector status LED
No light up : projector switched off
Green color : projector in Operational mode
Red color : projector is in Stand-by mode.
To start image projection, press the 'Stand by' button on the front local
control keypad or on the remote control. The projector mode status
LED lamp will be green.
When switching 'on' with the power switch, the projector starts in
the stand by mode. The projector mode status LED lamp is red.
FRONT CONTROL PANEL
+
+
+
+
+
0
9
7
8
6
5
4
3
2
1
+
BALANCE
+
+
VOLUME
+
BASS
+
CONTRAST
TREBLE
BRIGHTNESS
COLOR
TINT
SHARPNESS
ADJ
FREEZE
MUTE
PHASE
EXIT
PAUSE
TEXT
STBY
ENTER
B
B
B
B
B
B
B
B
B
B
ADDR
REMOTE CONTROL PANEL
HELP
Stand-By button
Power Switch
Projector Status LED
Switching to stand-by
When the projector is running and you want to go to stand-by, press
the stand-by key.
Caution
: Before powering down the projector, switch the projector
to stand-by and let the projector lamp cool down until the fans stop
blowing (or for at least 15 minutes).
Switching off
To switch off:
- press firstly the
STAND-BY
key and allow projector to cool down
until the fans stop blowing (or at least 15 min).
- then switch off the projector with the power switch on the front local
control panel.
Switching on
Use the power switch to switch on the projector, using the switch
on the front local control panel.
When '0' is depressed, the projector is switched off.
When '1' is depressed, the projector is switched on.
The projector is switched ON and OFF using the power (mains)
switch ON/OFF on the front local control panel keyboard
To gain access to the keyboard, refer to 'Front local Control panel
description and function' in chapter 1 'Location and function of
control'.
1 Pressed : ON
0 Pressed : OFF
Lamp reference number description,
N
o
-R9829510 :
1000
hrs.
N
o
-R9829600 :
3500
hrs in continuous operation.
30 hours before the end of lamp lifetime, the following message will
be displayed for 1 minute. This message will be repeated every 30
minutes. Press EXIT to remove the message before the minute is over.
When the end of lamp lifetime is reached, the following message, with
the exact run time is displayed on the screen.
The total life time of the lamp for safe operation is 1000 hrs
(N
o
R9829510) max. and 3500hrs (N
o_
R9829600) max.
Operating the lamp longer than the lamps corresponding hours may
damage the projector
. Replace always with a same type of lamp.
Call a BARCO authorized service technician for lamp replacement.
:$51,1*
/DPSUXQWLPHLVKRXUV
2SHUDWLQJWKHODPSORQJHU
WKDQKRXUVPD\GDPDJH
WKHSURMHFWRU
3OHDVHUHSODFHWKHODPS
(17(5!WRFRQWLQXH
Lamp run time
980 h
Lamp life
WARNING : Using a lamp for longer than its
recommended lifetime is dangerous, the lamp
could explode.