Service Mode
10-3
5975958 RETRO GRAPHICS 2100 210198
Identification
To display the Identification screen, press the control disc forwards
or backwards to highlight
Identification
and press
ENTER
to display
the
Identification
screen.
The Identification screen gives an overview of :
- type of projector
- projector address
- soft version
- installation configuration
- baud rate
- text ON
- projector serial number
- projector run time
-
type
of projector
: BARCO GRAPHICS XXXX
-
proj. address
: to change the address of the projector, see
Change Projector Address in this chapter.
-
software version
-
installation
: Allows for the possible installations configurations:
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
This function is not a valid alternative for a retro projector and should
be ignored.
-
baud rate
: transfer speed for communication with a IBM PC (or
compatible) or MAC. The baud rate of the projector must be the same
as the baud rate of the connected computer. When there is a
difference, consult Set up of the baud rate for commu-
nication with a computer in chapter Connections.
-
projector run time
: gives the total run time since the first start
up. All projectors leave the factory with a run time of approximately
24 hours.
-
projector serial number
: indicates the fabrication number of
the projector. This number can be useful when calling for technical
assistance.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUN TIME
LAMP RUN TIME HISTORY
MORE ...
How to change the password ?
Highlight Change password by pressing the control disc forwards
or backwards and press
ENTER
to display the Change Password
menu.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUN TIME
LAMP RUN TIME HISTORY
MORE ...
Press
ENTER
to save the new entered password.
Press
EXIT
if no changes have to be made.
The old password is displayed and can be changed by entering the
digit with the numeric keys of the RCU or local key panel.
ENTER
displays the Change Password menu
EXIT
returns to the adjustment selection menu.
CHANGE PASSWORD
Enter new password
0000
Select with or
then <ENTER>
<EXIT> to return.
Change Password
This item is password protected when the password strap is
installed.
How to enable or disable the password function ?
The password function is enabled when the password strap on the
controller module is installed.
To change the setting of the password strap, consult a qualified
service technician or an authorised BARCO service centre.
