Connections
6-8
5975348 BARCOVISION 8200 280497
Loosen the locking
Open the top cover
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 Hz
RS232 OUT
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
I R- A CK NO WL E DG E D
I R- RECE I V E D
DIA GNO STICS
CO DE
I R- RECE I V E R
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 Hz
RS232 OUT
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
I R- A CK NO WL E DG E D
I R-RE CE IV E D
DI AG NO STICS
CO DE
I R- RECE I V E R
Processor module
1
3 2
S2
S1
Baud rate switches
Change the position of the DIP switches with a small screwdriver.
If all switches are in the correct position, close the top cover and
secure it by turning the lock screw clockwise. Connect the power
cord to the wall outlet and switch on the projector.
Baud rate setting
baud rate
S2/1
S2/2
S2/3
9600
OFF
OFF
OFF
4800
ON
OFF
OFF
2400
OFF
ON
OFF
1200
ON
ON
OFF
600
OFF
OFF
ON
300
ON
OFF
ON
150
OFF
ON
ON
75
ON
ON
ON
Connecting a RCVDS 05 to the projector.
- Up to 10 inputs (20 when video inputs) with the RCVDS 05 and 90
inputs when RCVDS's are linked via the expansion module.
- Serial communication with the projector.
- Remote control buttons on the RCVDS to control the projector
(source selection and analog settings).
- The selected source number will be displayed on a 2 digit display
and the selected input module will be indicated with a LED on the
rear.
For more information about the use of the RCVDS 05, consult the
owner's manual, order number : R5975765.
Connecting a VS05 to the projector
The VS05 can switch up to 5 Composite Video sources, 3 Super
Video sources and 1 RGB analog or component video source to the
projector. In addition, the audio signal proper to the source, can be
switched to an audio amplifier.
Order number : R9827890
For more information about the use of the VS05, consult the VS05
owner's manual, BARCO order number : R5975245.
Connecting an IR Remote Receiver 800 to the
projector.
This infrared red receiver unit makes it possible to control the
projector from another room.
There is a communication line cable between the IR receiver and the
projector or the RCVDS. The control information from the RCU can
now be sent to the IR Remote Receiver 800.
The IR Remote Receiver 800 displays the selected source on a 7-
segment display.
Order number : R9827515.
Screen
Communication cable
Projector
IR Remote Receiver 800
Projection room
Control room