Barco Njord, User Manual

Page: 20 / 72

R5913592 / Njord 20
45° 45° 45° 45° 45° 45°
Image 2 – 5
For detailed info about the RCU see chapter “ Pulse Remote Control Unit ” , page 25.
2.2 Power on the projector
How to power on
1. Does the OVERVOLTAGE status light (reference 1) lit up?
► If yes, pull out the power cord immediately. Contact a qualified technician to check the power net.
Warning: Never switch on the projector if the OVERVOLTAGE status light lit up. Neglecting will
cause irreversible damage to the projector.
► If no, proceed with the next step.
2. Press the mains switch (reference 2) to switch on this projector.
2
1
OVERVOL
TAGE
Image 2 – 6
• When '0' is pressed, the projector is switched off.
• When 'I' is pressed, the projector is switched on.
The projector starts up to standby mode. The Power on/off button will blink until standby mode is
achieved. Once in standby mode, the Power on/off button will be lit WHITE, but the display will be off.
Image 2 – 7
3. Press the Power on/off button on the projector, or the Power On button on the remote control.
The projector will continue to power on mode. The Power on/off button will blink until the projector is
ready. Once the projector is ready, the Power button will be lit BLUE.
The start up screen is displayed on the touch panel and when fully started up, it changes to the overview
screen.
Getting Started