Barco Njord, Installation Manual

Page: 158 / 232

R5913593 /01 Njord 158
12.2.2 Projector address
About individual projector address
As more than one projector can be installed in a room, each projector should be separately addressable with
an RCU or with a computer using serial communication. Therefore each projector has its own address. The
factory default individual projector address is
‘ 0 ’ .
When the address is set, the projector can be controlled with the RCU. Only addresses between 0 and 31 are
supported for the RCU.
Next to an individual projector address, each projector has also a broadcast address for group control.
How to change
1. In the main menu, select Settings → Communication → IR Control .
Image 12 – 7 Communication menu, IR control
The IR control menu is displayed.
2. Select the current projector address and enter a new address.
3. Select APPLY and click OK to apply the changes.
From now on the projector will only listen to this new address and to its broadcast address.
GUI – System Settings