STEP5: Using the NGS web interface
11
7
STEP5: Using the NGS web interface
7.1
Pre-configured network settings
After the installation of the MGS software, the unit is pre-configured with a default IP
address.
The default network settings are as follows:
7.2
Starting the web interface
The web interface provides access to configuration and operating parameters of the NGS-
V161.
The web interface runs in a standard web browser. It can be accessed from any PC within
video network.
To start the web interface:
•
On the computer open a web-browser.
•
Enter the IP address of the NGS-V161 into the address bar of the browser. If it had not
been configured yet, the streaming network interface of the unit has the default factory
IP address https://172.16.0.2. The browser will display the web interface.
NOTE
:
Accept the certificate before the web browser opens.
When the web interface has started, its home page can be seen. On the left hand side there
is a navigation-menu, which provides access to the different kind of settings. Each section
can be accessed on an individual page.
The web interface can be used in three different modes: standard user mode (without
login), Barco mode and administration mode. Depending on this mode the menu as well as
the possibility to configure settings on the respective pages differs. The mode can be
switched by logging in or out.
IP address
172.16.0.2
Net mask
255.248.0.0
Default gateway
172.16.0.1
DHCP
Disabled
