Barco NGS-D200, User Manual

Page: 37 / 90

Chapter 8: Streaming
Field Default Value Valid Entries
Use Authorization
Table
No No, Yes
Profile
Remote Desktop
Interaction Remote Desktop Interaction, High Resolution Graphics, Full Motion
Video, Custom
Max Bandwidth 10.0 M N/A
Low Compression 6 0-10
High Compression 6 0-10
Table 8-1: Default/Valid Connection Profile Settings
l
Use Authorization Table: Enable this if you wish to use an Authorization Table. This protects unwanted access to
your encoder by authorizing only clients from specific IP addresses or networks to connect to the encoder.
N
OTE: After enabling this field and clicking "Apply", the Authorization Table section of the page will
appear.
l
Profile: Select the appropriate Connection Profile
o
Remote Desktop Interaction - optimized for capturing computer desktop screens
o
High Resolution Graphics - optimized for highest image quality
o
Full Motion Video - optimized for high frame rate
o
Custom - create your own custom profile
N
OTE: You wlll only need to configure the following settings if you select a "Custom" Profile
l
Bandwidth: Sets the bandwidth that the encoder will allocate for the decoder (client) to consume (Mbps)
l
Low Compression: Sets the compression level applied to portions of the input video where the image is static or
has very little motion (e.g. mouse cursor moving). Values between 0-7 are recommended for the best visual results.
Higher values (8-10) are recommended for networks with bandwidth constraints
l
High Compression: Sets the compression level applied to portions of the input video where the image is detected
to be dynamic. Values between 0-7 are recommended for the best visual results Higher values (8-10) are
recommended for networks with bandwidth constraints
N
OTE: When you have finished making changes, click "Apply" at the bottom of the page. Click "Save Settings" to
permanently save your changes to the device.
T
IP: See Appendix II for additional instructions on making connections between units.
8.2.2 Encoder Splash Parameters
The encoder will display a splash screen when there is no local input video detected. You can configure the settings of the
splash screen or force the splash screen to always display with this menu.
29
NGS-D200 User Guide