Barco Medea series, Installation Manual

Page: 13 / 74

R5906141 /02 Medea series 13
Label image Label description
Label location
Hazard RG3: optical radiation warning symbol.
Medea-M :
837
3
For North America: THIS PRODUCT IS IN CONFORMITY WITH
PERFORMANCE STANDARDS FOR LASER PRODUCTS UNDER 21 CFR
1040, EXCEPT WITH RESPECT TO THOSE CHARACTERISTICS
AUTHORIZED BY VARIANCE NUMBER 2017-V-4837 EFFECTIVE
September 13, 2017.
This projector may become RG3 when an interchangeable lens with throw
ratio greater than 3.5 is installed. Refer to the manual for the lens list and
hazard distance before operation. Such combinations of projector and lens are
intended for professional use only, and are not intended for consumer use.
Ce projecteur peut devenir un projecteur RG3 en cas d'installation d'un objectif
interchangeable dont le rapport de projection est supérieur à 3.5. Veuillez vous
reporter au manuel pour en savoir plus sur la liste des objectifs et la distance
de sécurité avant toute utilisation. De telles combinaisons entre projecteur et
objectif sont conçues pour des applications professionnelles uniquement et
pas pour des applications grand public.
本投影机安装透射比大于 3.5 的可换镜头后，可成为 RG3 ，操作前， 请参考手
册中镜头清单和危险距离。本投影机与镜头组合仅供专业使用，非普通消费者
使用。
1.4 Risk Group 3 Safety
1.4.1 General considerations
Notice on optical radiation from Medea Projector when it becomes Risk Group 3.
• For RG3, no direct exposure to the beam shall be permitted.
For RG3, operators shall control access to the beam within the hazard distance or install the product at a
height that will prevent eye exposure within the hazard distance.
• This projector has one or several built-in Class 4 laser clusters. Disassembly or modification is very
dangerous and should never be attempted.
• Any operation or adjustment not specifically instructed by the user ’ s guide creates the risk of hazardous
laser radiation exposure.
• Do not open or disassemble the projector as this may cause damage by the exposure of laser radiation.
FOR PROFESSIONAL USE ONLY means installation can only be carried out by Barco AUTHORIZED
PERSONNEL familiar with potential hazards associated with high intensity light beams.
WARNING: No direct exposure to the beam within the hazard distance shall be permitted, RG3
(Risk Group 3) IEC 62471-5:2015
CAUTION: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Safety