Input selection
6
Input selection
The MDSC-1119/MDSC-2124 can be equipped with numerous different
video inputs. The available inputs may depend on the customer’s
requirements.
Input selection can be done in 5 ways:
• Automatically, by means of the Source Scan system
• By assigning a source priority
• Quick input selection by using the general purpose switch.
• Quick input selection by using the navigation keys without
entering the OSD.
• Using the Input selection menu in the OSD.
These 5 possibilities are described more in detail below.
Source scan
Source scan is a system that automatically scans all video inputs in the
display until it detects a correct video signal at one of the inputs. When
that video signal disappears again, the source scan system
automatically starts again, looking for another video signal.
The source scan system can be enabled or disabled in the Setup menu.
Source priority
In the Setup menu you can give priority to an input source.
If a priority
has been established, the display will automatically select this source if
a signal is present on this input. The priority input selection will overrule
the manual input selection. For more information, please refer to
“Setup”
on page 24.
