Barco MDMG-5221, User Manual

Page: 23 / 54

4. Daily operation
When the display is switched on , the power LED is blue . When the display is in stand-by mode , the
power LED is orange .
The power LED can be disabled in the OSD menus. Please refer to "Power status indi-
cator light", page 24 for detailed instructions on how to do this.
In case of a power outage recovery, your display will always start-up in the power mode
it was in before the power interruption (i.e. standby or on). This protects your display
against inadvertent image retention problems.
4.4 I-Luminate
About I-Luminate
When the display is in power on mode and the OSD menu is not shown, I-Luminate can be activated by
touching the
key.
I-Luminate supports three modes:
• Full-screen luminance boost.
• Film 18 x 24 mode.
• Film 24 x 30 mode.
For both fi lm modes the position can be set to:
• Left
• Center
• Right
When touching the I-Luminate key, the display will enter the default I-Luminate mode, according to the
current setting, for approximately 1 minute. Touch the I-Luminate key again to immediately switch back
to normal mode.
While activated, the I-Luminate mode can be changed by using the key.
The default I-Luminate mode can be set in the OSD menu. Please refer to "I-Luminate
default mode", page 27 for detailed instructions on how to do this.
The I-Luminate fi lm position can be set in the OSD menu. Please refer to "I-Luminate
fi lm position", page 27 for detailed instructions on how to do this.
4.5 RapidFrame
About RapidFrame
The RapidFrame feature, eliminating blurry artifacts and ghosting in multi-frame image sequences, does
not need any user interaction. After starting up, RapidFrame will reach full effectiveness after the display
warms up.
K5902035 MAMMO TOMOSYNTHESIS 07/12/2017 21