7. Replacing a display in a display wall
7
Replacing a display in a display wall
In case a display is broken and needs to be replaced, proceed like this:
Note the position of the display in the wall.
Disconnect the broken display from the network and physically exchange the broken display by a new display.
Make sure that the broken display is no longer connected to the network!!
Write down the serial number of the new display – the serial number is listed on the product ID label
In BCM client, click
Setup
on the menu bar. The display wall is shown (and could be edited). Click
Next
.to access
the dialog allowing assign/unassign a display:
Make sure that IP Readdressing is checked!!
Select the position of the replaced display in the grid and click
Unassign
to remove the display from the wall
setup.
The information box next to the display will already show the new device!
Click
Assign
. The first entry in the information box is selected.
Click
Skip
until the identify pattern becomes visible at the new display.
Barco - Barco Wall Control Manager OVD/KVD/IVD - R591337 - user manual - Revision 04 - March-2016
_______________________________________________
57