C-1
Appendix C: Cleaning the Dustfilter
5976367 BARCO IQ-G300 24092001
C
Filter 3 (X-Cube filter)
Filter 1 (lamp1)
Filter 2 (lamp2)
%RWWRPYLHZRIWKH,43URMHFWRU
Filter 4 (Input filter)
CLEANING THE DUSTFILTER
Cleaning the dustfilter
When should it be done ?
Depending on the environement, the dust filters should be cleaned at least when replacing the lamp.
When the projector operates in dusty environement, clean the dust filters on a regular basis.
Note on the X-cube filter :
If the airflow is falling under a predetermined treshold value a warning will be displayed on the screen (see appendix B). At that time
it is strongly recommended to replace or clean the dustfilter under the X-cube (filter 3 on image1). Failing to do so, will strongly reduce
the lifetime of the LCD's and the analysers. The manufacturer reserves itself the right to refuse warranty repair if the projector was
working with dirty dustfilters.
How to clean the dustfilter ?
There are 4 filters located as shown on image 1
To clean the dustfilters, follow the next procedure :
1
Place the projector to access easily the filter to be cleaned (image 2)
2
Push the handle downwards to unlock the filter (image4).
Image 3 shows the handle of filter 3 (x-cube filter)
3 Slide out the filter as shown on image 4
4
Clean the dust filter with a dry cloth.
5
Re-insert the dust filter by sliding it back in the filter housing.
Image 5 on next page shows the 3 filters removed from the projector, the largest being the X-cube filter.
Remove the input air filter as shown on images 6&7.
image3: illustration of the handle of filter 3
Image 1
Image 2
