Barco Galaxy WARP 10 HB, Owner'S Manual

Page: 140 / 155

8. Service Mode
To adjust the light output in case of a single, stand alone projector setup, set the CLO setting to [SLAVE].
8.8.3 Lamp Mode
What can be done?
The Lamp can be set to the normal or economic mode.
How to change the Lamp Mode Setting?
1. Push the cursor key ↑ or ↓ to highlight
Mode.
(menu 8-16)
2. Press
ENTER
to toggle between the different Mode settings.
Following Mode Settings are available:
[NORMAL] Normal Light Output
[ECONOMIC] Reduced Light Output
Table 8-3
(Lamp) Mode Settings
LAMP
CONSTANT LIGHT OUTPUT [MASTER]
MODE [NORMAL]
_________________________________
Serial number : 003706
Article number : R9840740
Run time : 140 hours
Remaining run time : 1360
hours
Number of strikes : 160
Z-axis : 100 units
_________________________________
Select with
↑
or
↓
<ENTER> to toggle
<EXIT> to return
Menu 8-16
8.9 Barco Logo
8.9.1 Starting Up Barco Logo
What can be done?
The Barco Logo can be added to the projected image, in overlay or on a background, on any place on the screen.
How to Start Up the Barco Logo?
1. Push the cursor key ↑ or ↓ to highlight
More.
(menu 8-17)
2. Press
ENTER
to select.
The other items in the
Service
menu will be displayed.
3. Push the cursor key ↑ or ↓ to highlight
Barco Logo.
(menu 8-18)
4. Press
ENTER
to select.
The
Barco Logo
menu will be displayed. (menu 8-19)
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
LAMP
MORE ...
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 8-17
SERVICE
BARCO LOGO
PRESET INPUT BALANCE 1
PRESET INPUT BALANCE 2
ELECTRONIC CONVERGENCE
DIAGNOSIS
DYNACOLOR
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 8-18
BARCO LOGO
STATUS [OFF]
BACKGROUND [OFF]
SHIFT
HOT KEY [OFF]
Select with
↑
or
↓
<ENTER> to toggle/select
<EXIT> to return
Menu 8-19
136 R5976698 BARCO GALAXY WARP™ 10 HB 05/04/2004