59
R5914654 /04
G62 series
2.
Display a test pattern by pressing the
Pattern
key on the remote control.
Note:
The projector cannot display the input sources during the boresight adjustment.
Image 3–33
3.
To focus the left bottom area of the screen (point 4 and 7), turn boresight screw B clockwise or counter-
clockwise.
4.
To focus the right bottom area of the screen (point 6 and 9), turn boresight screw C clockwise or counter-
clockwise.
5.
To focus the top corners of the screen (point 1 and 3), adjust the image back focus and focus by pressing
the
Zoom
and
Focus
keys on the remote control.
6.
To focus the center bottom area of the screen (point 8), turn boresight screw A clockwise or
counterclockwise.
7.
Repeat from step 3 until the image is as sharp as possible in the center, left, right, top, and bottom of the
screen.
3.13.3 Finalizing the image adjustment
What should be done?
After the boresight adjustment is complete, fix the lens support system and fine tune the image focus.
Required tools
Allen wrench 2.5 mm
How to finalize
1.
Tighten the three M3 screws securing the lens support system with a 2.5 mm Allen wrench.
Summary of Contents for G62
