Barco FL40-4K, User Manual

Page: 34 / 64

R5913251 /00 FS-FL40 MKII series 34
4.1 Approved lenses
Approved lenses
This table contains the lenses that are within the certification of the projector.
Partnumber Lens Name
Description (WQXGA)
R9801214 EN11 FLD 1.6 — 2.32:1
R9801218 EN12 FLD 0.74:1
R9801228 EN13 FLD 1.24 . 1.6:1
R9801209 EN14 FLD 2.37 — 3.79:1
R9801225 EN15 FLD 1.16:1
R9801249 EN16 FLD 3.8 — 6.5:1
R9801216 EN41 FLD+ 1.7 - 2.5 : 1
R9801226 EN42 FLD+ 0.8 : 1
R9801230 EN43 FLD+ 1.2 - 1.7 : 1
R9801211 EN44 FLD+ 2.5 - 4.6 : 1
R9801220 EN45 FLD+ Long Focus 0.8 - 1.21 : 1
R9801221 EN46 FLD+ Short Focus 0.8 - 1.21 : 1
R9801295 EN47 FLD+ 0.65 : 1
R9802241 EN61 FLDX 1.7- 2.5: 1
R9802242 EN63 FLDX 1.2 - 1.7 : 1
R9802243 EN66 FLDX 0.8 - 1.21 : 1
R9802244 EN67 FLDX 0.65 : 1
R9802232 EN68 FLD+ 0.28:1
R9801832 UST 90 FLDX 0.38:1
Lenses other than above listed may also be used, but the maximum throw ratio will be limited to
7.2:1.
All lenses up to 7.2:1 belong to RG2.
4.2 Replace a lens
Lens lever
The L40 lens mount and lens lever is designed to prevent damage to the lens board while providing an easy
and stable lens change procedure.
The lens lever, located at the bottom of the lens mount, slides between two positions, far left (default position
— unlocked) and far right (locked).
Always activate the projector shutter before attempting to remove or install a lens.
To do this, press the
shutter button on the keypad, or shutter Close on the remote, to activate the
shutter. The keypad button will illuminate red when the shutter is activated.
Press the
shutter button again, or shutter Open on the remote, to deactivate the shutter and
resume normal operation. The keypad button will illuminate white when the shutter is deactivated.
Lenses