1. Safety & Environmental Information
W
ARNING
:
No direct exposure to the beam within the hazard distance shall be permitted, RG3 IEC 62471-
5:2015
C
AUTION
:
Use of controls or adjustments or performance of procedures other than those speci
fi
ed herein
may result in hazardous radiation exposure.
Restricted access location
This product may only be installed in a restricted access location. The de
fi
nition of a “restricted access location" is a location for
equipment where both of following applies:
•
Access can only be gained by SERVICE PERSONNEL or by OPERATORS who have been instructed about the reasons for
the restriction applied to the location and about the precautions that shall be taken.
•
Access is through the use of the tool or lock and key, or other means of security, and is controlled by the authority responsible
for the location.
Why a restricted access location: This is a RG3 product. Based on international requirements, no person in allowed to enter the
projected beam within the zone between the projection lens and the related Hazard Distance (HD). This shall be physically impossible
by creating suf
fi
cient separation height or by placing optional barriers. Within the restricted area operator training is considered
suf
fi
cient. The applicable separation heights are discussed in "High Brightness precautions: Hazard Distance (HD)", page 6 .
Users de
fi
nition
Throughout this manual, the terms SERVICE PERSONNEL and TRAINED PROJECTIONIST refers to persons having appropriate
technical training and experience necessary to be knowledgeable of potential hazards to which they are exposed (including, but not
limited to HIGH VOLTAGE ELECTRIC and ELECTRONIC CIRCUITRY and HIGH BRIGHTNESS PROJECTORS) in performing a
task, and of measures to minimize the potential risk to themselves or other persons. The term USER and OPERATOR refers to
any person other than SERVICE PERSONNEL or TRAINED PROJECTIONISTS, AUTHORIZED to operate professional projection
systems.
The TRAINED PROJECTIONISTS may only perform the maintenance task described in the User & Installation manual. All other
maintenance tasks and service tasks must be performed by quali
fi
ed SERVICE PERSONNEL.
The DLP Cinema Systems are intended "FOR PROFESSIONAL USE ONLY" by AUTHORIZED PERSONNEL familiar with potential
hazards associated with high voltage, high intensity light beams generated by lasers. Only quali
fi
ed SERVICE PERSONNEL and
TRAINED PROJECTIONISTS, knowledgeable of such risks, are allowed to perform service functions inside the product enclosure.
Owner’s record
The part number and serial number are printed on a label which is stuck on the respective part. Record these numbers in the spaces
provided below. Refer to them whenever you call upon your Barco dealer regarding this product.
Product article number
Product serial number
Dealer
1.2
Important safety instructions
To prevent the risk of electrical shock
•
This projector should be operated from an AC power source. Ensure that the mains voltage and capacity matches the projector
electrical ratings. If you are unable to install the AC requirements, contact your electrician. Do not defeat the purpose of the
grounding.
•
Installation according to the local electrical code and regulations by quali
fi
ed technical personnel only.
•
This product is equipped with a three-terminal barrier strip for the connection of a mono phase power line with a separate
earth ground PE. If you are unable to install the AC Requirements, contact your electrician. Do not defeat the purpose of the
grounding.
•
The cross-sectional area of the conductors in the power supply cord shall be not less than
2.5 mm
2
(12 AWG)
, minimum 300
V. Take into account that the cable gland of the projector allows a cable diameter from 8 to 13 millimeter.
2
R5906846 DP2K-SLP SERIES 11/05/2017
