Barco DATA 708HS R9002230, Owner'S Manual

Page: 49 / 59

7-11
Service Mode
5975589 BARCODATA 708 HS 080998
A warning, permanent BOOST mode in use, will be displayed to inform
the user.
When text is on, this warning will be repeated every time a new
source is selected.
Memory banks
The user has the possibility to create 8 different memory banks for
each source. But, the maximum allowed quantity of menory banks
for all sources together is 32.
The option to create different memory banks for the same source can
be switched ON or OFF.
Highlight Memory Banks and press ENTER to toggle between ON and
OFF.
ON : different memory banks available.
OFF : only one memory bank available.
If different memory banks are available for a source and the memory
bank option is toggled to OFF, only the first memory bank will be used
to display the source.
How to create a new memory bank ?
- Select your source. The projector selects the last used memory
bank.
- Press ENTER and push the corresponding digit (between 1 and 8)
of a non existing memory bank. (The memory banks can be created
in random order, e.g. first creating bank 5 and later bank 2.)
- Make the necessary adjustments. When leaving the source, the
new created memory bank will be saved for later use.
Example : When source 1, video 15.6 kHz /60Hz is create on bank 4
and the vertical frequency changes to 50Hz, the projector will create
a new block (due to the vertical frequency change) with the same
bank number 4.
How to recall a specific memorybank for the actual source ?
When the memory bank option is ON and a source is selected, this
source will be displayed with the last used memory bank settings.
An on-screen menu will give a indication of the memory bank nummer
used. To switch to another memory bank :
- Press ENTER to select the next memory bank in increasing order.
or
- Enter the number of the desired memory bank with the digit keys.
In both cases, the on-screen indication will be update.
I2C Diagnostics
Highlights 'I2C Diagnostics' by pushing the control disk up or down
and press ENTER .
The I2C diagnostics menu gives an overview of the I2C failures inside
the projector.
To scroll through the failure list, push the control disk up or down.
The I2C address, IC number and module name will be given in I2C
diagnostic menu.
When no errors are detected, the following message will appear on
the screen :
"No errors on i2c-bus detected".
WARNING
PERMANENT
BOOST MODE
IN USE !
SERVICE MODE
PROJECTOR SETUP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Scroll with ê or é
then <ENTER>
<EXIT> to return.
I2C DIAGNOSTICS
Failures :
addr IC number
mod.name
48H IC200 DECODER
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
CRT DRIVE MODE
MEMORY BANKS: ON
COMMON SETTINGS
Select with ê or é
then <ENTER>
<EXIT> to return.