Barco CTHD-61B, User Manual

Page: 52 / 68

52 User Manual - Introduction
english
6.8 Picture by Picture (PbP)
You may choose to view two sources simultaneously as a picture by picture.
The PbP-function allows viewing of two images side by side or on top of each other.
Certain restrictions apply to how sources combine when using PbP.
To view PbP:
• Enter the INSTALLATION menu and activate the PICTURE BY PICTURE function
• Move down to PICTURE BY PICTURE SETUP
• Set up by selecting the sources you want under SOURCE 1 & SOURCE 2
• The following special options are available for Picture by Picture-usage:
960x1080@60 Hz/120 Hz, 960x1200@60 Hz/120 Hz, 1280x1600@60 Hz/120 Hz,
depending on projector model, see 5.7.1 Installation > EDID sub menu
6.9 Standby ECO mode
Power saving mode sending the projector into a deep sleep setting when in standby. Wake
up can be performed either by pressing the power button on the projector/remote control or
remotely via the RS232 connector using the ASCII protocol / wake on LAN via the ethernet.
If DPMS is enabled and a source signal becomes active again the projector will return to
normal operation.
When in standby ECO mode, the baudrate of the RS232 communication is fixed at 19200.
6.10 PIN code
The projector can be locked by a PIN (Personal Identification Number) code to control
access. The PIN code is 4 digits, and if the PIN code is activated, you must enter the
correct code to unlock the projector. Factory set PIN (1234).
To activate, deactivate or change the PIN code, see the
SETTINGS > PIN CODE
sub menu.
If an incorrect PIN code is entered, you may try again two times. If you fail three times
in a row, entering a PUK (unlock) code is needed. The PUK code is supplied with the
product.
If you also fail three times with the PUK code, the projector locks up permanently, and
can only be unlocked by a special service unlock code.
To access this code, you will need to contact your dealer or a service station. The service
unlock code will be generated based on a secure, encrypted number that is produced by the
projector itself. The projector will produce a new number every time.
In order to unlock the projector via a dealer/service station, proof of ownership must
be provided by the customer.
6.11 Disabling the wireless remote control (IR) receivers
The projector has 2 IR receivers, one in the front and one at the rear.
These receivers can be individually disabled if necessary. Go to menu entry INSTALLATION
> IR FRONT / IR REAR to disable the receivers.
CT series User Manual - Functionality