Barco Coronis Uniti MDMC-12133, User Manual

Page: 34 / 60

5. Advanced operation
5.9 Hibernate
About hibernate
Enabling hibernation will not only switch off the backlight but will also force the display to disable other
functionalities so that power consumption is further reduced to a minimum. This happens after a speci
fi c
period of time which can be manually adjusted.
Hibernate can only be enabled on your display when the DPMS mode is enabled fi rst.
Therefore, please refer to "DPMS mode", page 31 to do this.
To enable/disable hibernation on your display:
1. Bring up the OSD main menu.
2. Navigate to the Con fi guration > Power Management menu.
3. Enter the Hibernate submenu.
4. Select Enabled/Disabled as desired and con fi rm.
To specify the hibernate timeout:
1. Bring up the OSD main menu.
2. Navigate to the Con fi guration > Power Management menu.
3. Enter the Hibernate Timeout submenu.
4. Set the timeout value as desired and con fi rm.
5.10 I-Luminate default mode
About the I-Luminate default mode
The I-Luminate mode de fi nes the default activated mode during the I-Luminate boost. This mode can be:
Screen The boost mode is applied on the screen display.
Film (large or small) Film (large or small): the boost mode activates a
high illuminated rectangle on top of the screen,
simulating a light box for use with radiological
fi lm.
The size of this rectangle is similar to a classic
(large or small) radiological
fi lm.
To set the I-Luminate mode:
1. Bring up the OSD main menu.
2. Navigate to the Con fi guration > I-Luminate menu.
3. Enter the Default mode submenu.
4. Select Screen/Small Film/Large Film as desired and con fi rm.
32 K5902079 CORONIS UNITI 21/04/2015