Barco CLM HD8 R9050130, User Manual

Page: 177 / 197

D. Troubleshooting
D. TROUBLESHOOTING
D.1 Error codes
Overview
When the error code is preceded by a ’-’ sign, then the error means a real error for the projector.
When the error code is preceded by a ’+’ sign, then the error code means a warning. The projector does not fail yet, but take care
for the warning and try to resolve the problem. A warning state can turn into an error state.
Not all error codes can have two states. When the state is available, it is indicated by a Yes in the overview table. When the state
is not available, it is indicated by a No.
Error
code Description Error Warn-
ing Caused by Action
1000 Wrong lamp
parameters Yes
-
Wrong lamp/ no communication
with lamp Check lamp type
Call a qualified service engineer
1399 I²C open error Yes
1398 I²C read error Yes
1397 I²C write error Yes
1499 Video input
invalid
1498
1699 Formatter
busy
1698 Formatter
address
1697 Formatter init
failed Yes
-
no communication with formatter
ctrl Call a qualified service engineer
1696 Formatter ctrl
init failed Yes
-
no communication with formatter
ctrl Call a qualified service engineer
1695 Formatter
start failed Yes
-
no communication with formatter Call a qualified service engineer
1694 Formatter
PWGGood Yes
-
formatter ’Power Good’ signal not
OK Call a qualified service engineer
1999 MAX7301 not
initialized Yes
2000 No lps
detected Yes
-
no communication with lamp power
supply Call a qualified service engineer
2001 Mains voltage
too low Yes
-
mains voltage too low
2002 Lamp start
failed Yes
-
Hot restrike
Lamp with many strikes
maximum run time exceeded
Lamp or LPS or SPG failed
Let cool down the lamp for at least
5 minutes. Retry a few times.
Replace the lamp with a new one
Replace LPS or SPG or cabling.
2003 Main voltage
too high Yes
-
mains voltage too high
2004 Lamp goes out Yes
-
Call qualified service engineer
R59770057 CLM HD8 16/07/2007 173