![background image](http://html1.mh-extra.com/html/barco/cine7-r9010040/cine7-r9010040_installation-manual_4236432030.webp)
5. Installation Adjustment
CRT PROJECTION ANGLE
ADJUSTMENT
CRT PROJECTION ANGLE IS THE
FIRST STEP OF STATIC
CONVERGENCE ADJUSTMENT
IT IS CRITICAL THAT THE
RASTERS ARE CENTERED ON
THE CRT FACE PLATES PRIOR
TO PERFORMING THIS STEP
<ENTER> to continue
<EXIT> to return
Menu 5-11
Never try to correct this misalignment with the shift correction or the static convergence controls. These shift
correction controls may only be applied to correct small errors which cannot be corrected by the CRT angle
adjustment. The Horizontal Shift and Vertical Shift for Red and Blue should be set near 50%.
Be sure that the rasters are centered on the CRT faceplate.
How to adjust the CRT Projection Angle?
1. Press
ENTER
to continue with the crosshair alignment.
Following screen will be displayed: (menu 5-12)
2. Press
ENTER
to begin with the angle adjustment of the Red CRT.
3. Loosen the four hexagon screws A, A’, B and B’, upper and lower fixation latch. These screws fasten the cooling house of the
red tube. Pivot the red CRT until the center of the red image coincides with the center of the green image. If the angle of the red
CRT is corrected, tighten the four bolts. (image 5-7, image 5-8)
Note:
Screws A, B, C and D (M4) : upper fixation latch. nutdriver 7mm.
Screw A’, B’, C’ and D’ (M4) : lower fixation latch. nutdriver 7mm.
4. When the angle of the Red CRT is corrected, tighten the four bolts.
5. Press
ENTER
to continue with the angle adjustment of the Blue CRT.
6. Loosen the four hexagon screws C, C’, Dand D’, upper and lower fixation latch. These screws fasten the cooling house of the
blue tube. Pivot the blue CRT until the center of the blue image coincides with the center of the green image. If the angle of the
red CRT is corrected, tighten the four bolts. (image 5-9)
7. When the angle of the blue CRT is corrected, tighten the four bolts.
8. Press
ENTER
to continue.
CRT PROJECTION ANGLE
ADJUSTMENT
DURING THIS PROCEDURE? RED
ON GREEN AND THEN BLUE ON
GREEN CROSSHAIRS WILL BE
ALIGNED WITH THE GREEN CRT
LOOSEN BOLTS A, B, C AND D TO
PIVOT THE RED CRT AND BOLTS
E, F, G AND H TO PIVOT THE
BLUE CRT
<ENTER> to continue
<EXIT> to return
Menu 5-12
26
R5976585 BARCO CINE7 26022003
Summary of Contents for CINE7 R9010040
