Getting Started
3-4
5976227 BARCOCINE 8 13042001
Start up in Operational Mode
The projector can start up with the selected source or
the projector can start up with a warm up cycle message (menu 1).
PROJECTOR WARM UP
A FULL WHITE PATTERN WILL BE
GENERATED FOR 20 MIN.
FOR IMMEDIATE USE OF THE
PROJCTOR, PRESS <EXIT>
WARNING : SKIPPING THIS
PROCEDURE CAN REDUCE THE
INITIAL PICTURE QUALITY OF THE
PROJECTED IMAGE;
YOU CAN ADJUST THE IMAGE
DIMENSTIONS WITH THE ARROW
KEYS TO AVOID SCANNING ON THE
EDGES OF THE CRT'S;
THIS OPTION CAN BE DISABLED IN
THE SERVICE MENU
with <ENTER>
<EXIT> to return
menu 1
When this warm up cycle message appears on the screen, the menu offers the possiblity to start with this 20 minutes taking warm
up periode (press ENTER) or to skip this cycle (press EXIT).
Note : This warm up periode is built in so that the projector can reach its maximum specifications and minimize all distortions.
When starting this warm up period, a full white image is shifted on the CRT faceplate to avoid a burn in. Every 30 seconds a text box
will be displayed on another place on the screen with the remaining time to go.
To interrupt the warm up period, handle as follow :
1
Press EXIT, the warm up menu will be redisplayed with the remaining time indication.
2
Press EXIT again to quit the warm up cycle and to display the source.
Start up in Stand by Mode
The projector starts up in stand by.
Press a digit key corresponding to the desired source or press STBY key.
The projector displays the selected source or the warm up cycle message.
When this warm up message appears on the screen, handle as described in 'Start up in Operational Mode'.
Warning
Do not display a stationary image with full brightness and contrast for longer than 20 min., otherwise you risk damage to the CRT's.
RCU Commands to the Projector
Pointing the RCU to the reflective screen
Point the front of the RCU to the reflective screen surface.
Ceiling
Screen
IR sensor
RCU
