31
You are strongly advised to ensure that privileged access
to your terminal is only granted to staff that have been
independently verified as being trustworthy.
The terminal must never be put in or left at a location where it
could be stolen or replaced by another device.
Before installing SAM or μSD or SIM, switch off the terminal
by disconnecting the power supply.
Use only paper approved by Ingenico (diameter 40mm). Use
of unsuitable paper is likely to damage the printer of your
terminal. Switch off the terminal prior to installing a paper roll.
In order to benefit from the complete guarantee of the
product, use
Ingenico approved thermal paper only.
Do not stick any conductive label on to the contactless active
zone located on the paper trapdoor button. It can decrease
seriously contactless efficiency.
Before making any operations of maintenance in the terminal,
make sure that the power supply is disconnected.
Do not use in any case,
solvents, detergents or abrasive
products. Those materials might damage the plastic or
electrical contacts.
Recommendations / Safety
Power on/Power down – Emergency stop
To power on or power down the terminal connect or
disconnect the power supply from the electric outlet.
Lithium battery cell
The terminal is fitted with a lithium battery cell which is
not accessible to the user. Only a qualified technician is
authorized to open the unit and change this component.
Electrical power outlet
The electrical outlet must meet the following criteria:
• must be installed near the equipment and easily accessible
• must meet standards and regulations in the country of use
• for type A plug, the protection of the installation must be
set to 20 A
• except for Norway do not connect on an IT electrical
network
Telephone network
The phone network must comply with standards and
regulations in the country of use.