Barbecook VANILLA 223.9988.000, Installation Instructions Manual

Page: 28 / 120

28 www.barbecook.com
solVInG problems
Problem
Probable cause Solution
Impossible to light burner (with igniter
or match) • Blocked venturi tubes • Clean venturi tubes
Not enough heat • Gas cylinder valve is not open
• Venturi tubes not positioned over exhaust valves
• Blocked burner openings
• Cylinder is empty or almost empty
• Regulator not fitted correctly on cylinder • Open gas cylinder valve
• Reinstall venturi tubes
• Clean openings or fit new burner
• New cylinder
• Tighten up connector of regulator
• Disconnect hose
Yellow flames • Venturi tubes are partly blocked
• Salt on burner • Clean venturi tubes
• Clean burner
Impossible to light burner with igniter • Ignition wire not fitted properly
• Defective ignition electrode
• Faulty ground
• Defective igniter
• Check all connections
• Check installation of electrodes, burner and igniter
• Replace igniter
Flames jumping out of the burner box • Windy weather
• Cylinder almost empty • Move barbecue with rear side pointing towards the wind
• New cylinder or fill up
Excessive heat and flare-ups • Too fatty food
• Blocked fat drain hole
• Cooking system not positioned correclty • Trim excess fat or reduce heat
• Clean bottom of burner box and burner
• Position cooking system correctly
Flames behind control panel • Blocked venturi tubes • Shut off gas immediately, allow barbecue to cool down and
clean venturi tubes
Regulator humming • Temporary situation caused by high outside temperature or
full cylinder
• This is not a defect or a hazard
Incomplete flame • Plugged, leaky or rusted burner • Clean / replace burner
Warming rack does not fit • Legs are angled too narrowly, or too widely • The warming rack feet are adjustable. Bend them to fit into
the warming rack holes.
TroUblesHooTInG GUIDe For eleCTrIC IGnITIon
Problem Probable cause Solution
No sparks when pressing the ignition;
no sound • Battery not installed correctly
• Empty battery
• Ignition button not installed correctly
• Defective spark generator
• Install battery (ensure that Ò+Ó and Ò-Ó are oriented cor-
rectly, with Ò+Ó at the top and Ò-Ó at the bottom)
• Replace with new AA battery
• Screw off button and reinstall
• Replace spark generator
No sparks when pressing the ignition;
sound is present • Faulty ground • Remove and reconnect all connections with spark generator
and electrodes
Sparks are present but not with all elec-
trodes and/or not powerful enough • Faulty ground
• Spark flashover away from burner(s)
• Low battery
• Electrodes are wet
• Electrodes cracked or brokenn “sparks are present”
• Remove and reconnect all connections to the spark genera-
tor and the electrodes
• If sparks are present that do not originate from the
burner(s), the wiring may be damaged. Replace the wiring.
• Replace with new AA battery
• Use paper tissues to remove the dirt
• Replace cracked or defective electrodes
TURBO HEATING SYSTEM
An additional feature is the new Turbo Heating System: your
barbecook is immediately ready to grill and the heat is distri-
buted optimally.
Advantage: barbecook uses 20% less gas than any other gas
barbecue.
Man_VANILLA_KADUVA_110517_A.indd 28 17/05/11 13:57