Barazza 1PZP9N, Instruction Manual

Page: 29 / 60

21
MOUNTING INSTRUCTIONS
Mount the cooker hood as shown in the pictures of the mounting manual attached.
The cooker hood is heavy and in order to move it 2 persons are needed.
During the installation of the cooker hood, always wear protective handgloves to prevent injuries.
The appliance is developped to be installed into a working top.
Prepare the sealing material along the entire perimeter
(Fig. 2)
Block the domestic appliance into place with the supports, keeping the thickness of the surface
in mind. If the lower part of the appliance after installation is accessible from the lower part of
the furniture, it is necessary to mount a separating panel respecting the distances given.
(Fig. 1)
VENTILATION
The distance between the induction hob and the kitchen furniture or built-in appliances must be
such to guarantee sufficient ventilation and discharge of the air.
Do not obstruct the front cooling slots in order to prevent malfunctioning of the appliance.
(Fig.
3)
Do not use the induction hob if pyrolysis process is in execution in the oven.
BEFORE ELECTRICAL INSTALLATION
Before connection you must:
■
check that the building/room is fitted with electric safety system to protect against short
circuits and electric shock systems according to law in force.
■
always turn off the main voltage supply by means of the bipolar switch before connecting
and switch on again only when connections have been completed, tested and are safe.
■ the earth wire is 2 cm longer than the other cables;
■ the system ratings meet the ratings indicated on the rating plate applied in the product;
■ the system is fitted with efficient earth system in compliance with the laws and current standards.
Earthing is mandatory by law.
If the domestic appliance is not supplied with a cable and/or suitable plug, use material suitable for the
absorption value indicated on the identification plate and the operating temperature.
ELECTRICAL CONNECTION
WARNING
The product has got different speed cables.
The electrical connection can only be carried out by qualified professional personnel, using
standard material and state of the art installation methods. The manufacturer declines any
responsibility for installations carried out by unskilled persons and for installations which are not
in conformity with the standard norms concerning electrical safety (both concerning methods and
materials).
ELECTRICAL TECHNICAL DATA
The electrical technical data are visible in the rating plates of the products
CONNECTION TO THE POWER SUPPLY
If a direct connection to the mains is required, an omnipolar switch must be installed, with a
minimum 3 mm opening, between the contacts and suitable for the load indicated on the plate