Baracuda
®
Adventura™ Robotic Pool Cleaner | Owner's Manual
Section 5. Maintenance
5.1
Cord Tangling
IMPORTANT
The floating cable may become tangled if
correct procedure is not followed after each
cleaning cycle.
After every cleaning cycle:
1.
Unplug the floating cable from the
Control box.
2.
Remove the cleaner from the pool and
untangle all kinks and coils in the floating
cable starting at the cleaner head
(Figure 23).
Figure 23. Untangle the Floating Cable
3.
Plug the floating cable back into Control
box and store cleaner out of direct
sunlight for next use.
5.2 Replacing the Brushes
The cleaner is fitted with PVC brushes. There
are ''wear'' indicators (Figure 24) on the
brushes. To maintain cleaner performance at its
best you need to replace the brushes as soon
as one of the wear indicators has been reached
(even if the blade wear is not even). Baracuda
recommends that you replace the brushes
when the rubber is worn down to the top of the
wear indicator (or every two years, whichever
comes first).
Figure 24. Wear Indicators
1.
Stand the cleaner on its end in a vertical
position (Figure 25).
Figure 25. Stand Cleaner Upright
2.
Separate the edges of the brush, undo
the tabs, and remove the worn brush.
3.
Position the new brush matt underneath
the roller with the bristles facing
downwards. Refer to Figure 26.
Figure 26. Position the New Brush on Roller
4.
Thread each tab into the slot provided
and gently feed it through until the heel
comes out at the other side of the slot.
Refer to Figure 27.
11
