User
Manual
of
DMR
‐
5R
Digital
Two
‐
way
Radio
VFO mode
DMR
Inquire the operation mode in channel
mode and modify the operation mode in
VFO mode
INBOX
Inbox (not available temporarily)
30 MSG
Message
OUTBOX
Outbox (not available temporarily)
31
Contact
Digital contacts
Contact name
Set via frequency writing software
32
CC
Color code
0,1,…,15
Set color code value in digital mode
33
ENC-KEY
Encryption key
Key name
Set via frequency writing software
SLOT1
Time slot 1
34 BS-SLOT Time
slot
SLOT2
Time slot 2
35
CP Ver.
Software version
XXXXXX
Inquire software version number (date)
Note: MSG
，
CP Ver. doesn't support modification; ANI-ID needs to be modified via frequency writing software.
Auxiliary functions
Restore factory settings
In case of a failure of this two-way radio due to misoperation or setting error, resetting the microprocessor may solve the
problem. This function operation can be used to restore all settings and channels of this two-way radio to factory state. Memory data
and stored information may be lost during the resetting process. Before resetting, please back up or write down important data.
■
All reset
Execute the operation steps below:
1) Access to the menu by pressing [MENU] key.
2) Press [
S
] key or [
T
] key (or enter 28 directly) until the screen shows and the pointer points to RESET; then perform the
selection operation by pressing [MENU] key.
3) Press [
S
] key or [
T
] key until the pointer on the screen points to ALL; then execute all reset operation by pressing [MENU] key.
4) During operation, go back and exit from the menu mode by pressing [EXIT] key. By resetting, data shall be deleted and factory
settings of the two-way radio shall be restored, therefore, this function shall be used prudently.
■
VFO reset
"VFO reset" means resetting two-way radio parameters except DTMF memory, memory channel content and call channel
content. Execute the operation steps below:
1) Access to the menu by pressing [MENU] key.
2) Press [
S
] key or [
T
] key (or enter 28 directly) until the screen shows and the pointer points to RESET; then perform the selection
operation by pressing [MENU] key.
3) Press [
S
] key or [
T
] key until the pointer on the screen points to VFO; then execute VFO reset by pressing [MENU] key.
4) The screen shows WAIT… until the two-way radio is reset.
▲
During operation, go back and exit from the menu mode by pressing [EXIT] key. By resetting, data shall be deleted and factory
settings of the two-way radio shall be restored, therefore, this function shall be used prudently.
■
Troubleshooting guide
Problem Solution
Without power supply, the two-way radio
doesn't work.
The battery may has run out. Please replace or charge the battery.
The battery may be installed improperly. Please remove and reinstall the
