Bante520 Portable Conductivity Meter
10
Viewing the calibration report
3.1
Press the
MR
key in the measurement mode and the
or
key until the display shows
ELE/P-2.
3.2
Press the
Enter
key. The meter shows the calibration point 1 (e.g., 10.00µ S/cm).
3.3
Press the
key, the meter shows the calibration factor of the calibration point 1 (e.g., 0.991).
3.4
Press the
key again, the meter shows the next data set.
3.5
To exit the calibration report, press the
Meas
key.
If the meter does not calibrated, the display will only show
“
----
”
.
