2x
1x
Unlock push buttons
(flashing of both Green and Amber LEDs 1X followed by acceptance flash)
default
Lock push buttons
(flashing of both Green and Amber LEDs 2X followed by acceptance flash)
2x
Basic Configuration (alternating flashing Green and Amber LEDs at 1Hz)
Advanced Configuration (simultaneous flashing of both Green and Amber LEDs at 1Hz)
40 ms < T < 800 ms
Timing between Pulse groups > 800 ms
Remote Input Wire Pulse Timing (T)
(White wire is remote input wire)
3x
Toggle TEACH Button Lock/Unlock (flashing of both Green and Amber LEDs 4X followed by acceptance flash)
4x
Reset to Factory Defaults
** Remote Input Wire only.
(flashing of both Green and Amber LEDs 8X followed by acceptance flash)
8x
Push Button or
EMITTER
Remote Input Wire*
*Configuration using remote input wire
when enabled through IO-Link
High Speed (flashing of both Green and Amber LEDs 1X followed by acceptance flash)
Configure to A Frequency (flashing of both Green and Amber LEDs 2X followed by acceptance flash)
Configure to B Frequency (flashing of both Green and Amber LEDs 3X followed by acceptance flash)
Configure to C Frequency (flashing of both Green and Amber LEDs 4X followed by acceptance flash)
Configure to High Power (flashing of both Green and Amber LEDs 5X followed by acceptance flash)
2x
1x
4x
3x
5x
default
default
Configure to Low Power (flashing of both Green and Amber LEDs 6X followed by acceptance flash)
6x
Hold is > 2 sec. and < 4 sec.
Click is > 40 ms and < 800 ms
Push Button Input
**
**
** Remote Input Wire only.
Figure 10. Opposed-Mode Models Emitter Input Flowchart
WORLD-BEAM QS18 Expert with IO-Link
10
www.bannerengineering.com - Tel: + 1 888 373 6767
