Specifications
Button/Locking Collar
Polyamide/Aluminum
Insulation Resistance
100 MΩ minimum (500 V DC megger)
Rated Current (Ith)
5A
Impulse Withstand Voltage
2.5 kV
Pollution Degree
3
Overvoltage Category
II
Vibration Resistance
Operating extremes: 10 Hz to 500 Hz, amplitude 0.35 mm acceleration 50
m/s
2
Shock Resistance
Operating extremes: 150 m/s
2
(15G)
Direct Opening
Force: 80 N Minimum
Travel: 4.0 mm Minimum
Button Travel
4.5 mm Maximum
Contact Resistance
50 mOhm maximum (initial value)
Operating Frequency
900 operations/hour
LED Color
Red (The LED is built into the contact block and cannot be replaced)
LED Voltage/Maximum Current
24 V AC/DC ±10%, 15 mA
Total Weight of Padlock and Hasp (SSA-EB1M..-.. only)
1500 g (3.3 lb) maximum
Rated Insulation Voltage (Ui)
250 V
Operating Humidity
45% to 85% RH (no condensation)
Contact Material/Bounce
4
Gold plated silver / 20 ms
Electrical Rating
Minimum load: 1 mA at 5 V AC/DC
Maximum Rated Load:
See table
UL Applications: 1.5 A at 250 V AC, 1 A at 30 V DC (pilot duty)
CE Applications: AC-15: 1.5 A at 250 V AC, DC-13: 1 A at 30 V DC
Electrical Life
100,000 operations minimum, 250,000 operations minimum at 24 V
AC/DC, 100 mA
Output Configuration
Mechanical Life
250,000 operations
Terminals
M3 screw terminal (terminal cover included)
Recommended Torque: 0.6 to 1.0 N·m (5.3 to 8.8 in-lbf)
Allowable Wire: 0.75 to 1.25 mm
2
(18 to 16 AWG)
B10d
100,000 (based on ISO13849-1(2006))
Operating Temperature
Non-illuminated: –25 °C to +60 °C (–13 °F to +140 °F)
Illuminated: –25 °C to +55 °C (–13 °F to +131 °F)
Environmental Rating
Actuator: IP65 (IEC 60529)
Terminal: IP20 with SSA-EB1-FSTC installed
Standards
Design and Compliance
: EN/IEC 60497-5-1, EN/IEC 60947-5-5, UL 508, CSA
C22.2 No.14
Application and Other Applicable Standards (not all inclusive)
: ISO 13850,
ANSI B11.19, IEC 60204-1, NFPA79
Date code format (U.S. Standard Format)
YYWWX:
2-digit year, 2-digit week, "X” internal code
Certifications
S
Banner Engineering Europe
Park Lane,
Culliganlaan 2F bus 3, 1831 Diegem,
BELGIUM
Turck Banner LTD
Blenheim House,
Blenheim Court, Wickford, Essex SS11 8YT,
Great Britain
4
When the button is reset, the normally closed contacts will chatter. When pressing the button, the normally open contacts will chatter. When designing a control circuit, take the contact chatter time
into consideration. Do not expose the switch to external shocks, otherwise the contacts will bounce.
SSA-EB Series Emergency Stop Push Button
P/N 194992 Rev. D
www.bannerengineering.com - Tel: + 1 888 373 6767
7
