banks economind, Owner'S Manual

Page: 31 / 33

Section 8
CLEARING LEARNED INFORMATION
NOTE: If clearing the Six-Gun/
EconoMind’s learned parameters then
all Banks iQ tunable settings will be
reset to factory
defaults. (Refer to the
Banks iQ Owners Manual for more
detail.)
This procedure should only be
performed if:
- A ”4,2” code for transmission slip
detection is repeatedly set or will
not clear and the transmission is
not actually slipping; or
- The Six-Gun/EconoMind Diesel
Tuner is moved to a new vehicle;
or
- The vehicle’s speedometer has been
factory recalibrated for different
gearing or tire size; or
- Instructed to do so by Banks
Technical Staff. Your Six-Gun/
EconoMind Diesel Tuner also
has the capability to clear the
information related to the learned
transmission type and gear ratios.
The diagnostic code “4, 3” will
reappear after the procedures
are carried out correctly. Follow
the steps below to unlearn the
transmission on your Six-Gun/
EconoMind Diesel Tuner.
CAUTION: The following procedures
can only be carried out with the
engine not running.
1.
Turn the vehicle key to the ON
position but DO NOT start the engine.
2.
Fully depress the accelerator pedal
and then release it completely. Repeat
for 5 times. The GREEN LED will flash
when this is completed successfully.
3.
Turn the key OFF. Wait 10 seconds,
or until the GREEN LED goes off and
stays off. Turn the key to the ON
position but DO NOT start the engine.
4.
Fully depress the accelerator pedal
and then release it completely. Repeat
for 5 times. The “4,3” diagnostic
code will flash when this is completed
successfully.
NOTE: When the transmission type
and gear ratios are cleared (with code
“4,3” displayed), the engine power
returns and remains in stock level until
the Six-Gun/EconoMind Diesel Tuner
re-learns the transmission and the
“4,3” code is eliminated. Follow the
procedures in ”Transmission Learning”
(Section 6) to eliminate the “4,3”.
-END, SECTION 8-