banks economind, Owner'S Manual

Page: 29 / 33

of 2 digits. Each code is expressed in a
sequence of 2 sets of the flashing RED
LED separated by a brief flashing of the
GREEN LED in between. Each set of a
number of RED LED flashes represents
a digit. A longer flashing of the GREEN
LED separates the sequences. The
LEDs will continue to flash to display
all the errors, and then repeat. Table 1
lists the available diagnostic codes and
there commended course of action
for each. For example, if a faulty
thermocouple is detected (code “2,3”)
by the Six-Gun/EconoMind Diesel
Tuner, the following RED and GREEN
LED flashing sequence is observed
when the ignition is ON:
(1) Two times flashing RED LED
(2) One time quick flashing GREEN LED
(3) Three times flashing RED LED
(4) One time longer flashing GREEN
LED. The above flashing sequence
will repeat continuously. When the
problem is corrected, the diagnostic
code will be eliminated and replaced
by a steady GREEN LED.
NOTE: If multiple codes are set, they
will be displayed in a series separated
by the longer flashing GREEN LED.
When reading codes, make sure to
watch the entire series until you see
the first code repeat.
NOTE: The “4,3” code comes on when
the Six-Gun/EconoMind Diesel Tuner
module is first installed on a vehicle.
To eliminate this code, follow the
instructions described in “Transmission
Learning” (Section 6). If problem
persists, contact Banks Technical
Service.
If the Six-Gun/EconoMind Diesel Tuner
should ever need to be removed from
the vehicle, all vehicle connectors
must be reconnected to their stock
configuration. Failure to reconnect the
vehicle may result in a “Check Engine”
light on the dash and a Diagnostic
Trouble Code being stored in the
factory computer, and the engine may
not start. -END, SECTION 7-