banks economind, Owner'S Manual

Page: 16 / 33

stressed wire. Locate the RED/WHT
wire with the Power Terminal on the
Six-Gun/EconoMind tuner wire harness
and connect it to the mini-fuse blade
tap. Replace the fuse cover and make
sure not to pinch the RED/WHT power
wire.
NOTE: Go over the entire installation as
a precautionary check to ensure that
all clamps are tight, wiring and hoses
are properly routed, and connections
are correct and tight. Make sure that
the Six-Gun/EconoMind wire harness
is not lying in the way of the brake and
gas pedals, or any moving parts.
16.
(Engine Compartment) After
confirming all of the system connections
are correct, make sure the entire
mounting surface is clean and free of
dirt and oil before mounting the Six-
Gun/EconoMind Diesel Tuner. Clean
and dry as required using a cloth
dampened with rubbing alcohol or a
similar cleaning solution.
17.
Hold the Six-Gun/EconoMind
Tuner against the fuse box cover for
approximately 1 minute while applying
pressure to allow the adhesive to
properly adhere to the surface.
-END, SECTION 1-
CAUTION: Do not spray fluid
directly onto any electrical
equipment, or equipment damage
may result. Mount the Six-Gun/
EconoMind Diesel Tuner on the top
of the fuse box cover as shown in
Figure 2 , by peeling the protective
backing off the adhesive tape on
the back of the Six-Gun/EconoMind
Diesel Tuner.
Figure 13