Bang & Olufsen BeoVision 7 MK II, Service Manual

Page: 53 / 106

Service mode 4.7
BUS Ignore mode
Bus ignore mode is used if an error occurs in the IIC bus system which forces the
TV go into stand by every time an attempt is made to be switch it on.
The IIC error is ignored and the TV is swithed on.
IMPORTANT !
When the TV is switched on in BUS Ignore mode it may result in further damage
to the TV.
. Set the TV into stand by.
. Short-circuit the solder pads.
Marked R37 on coordinate E on PCB.
3. Switch on the TV.
The TV will switch on in BUS Ignore mode with the Service Menu active if possible.
4. Remove the short-circuit on the solder pads.
. To exit BUS Ignore mode. Switch off the TV.
➅