![background image](http://html1.mh-extra.com/html/bang-and-olufsen/beovision-7-mk-ii/beovision-7-mk-ii_service-manual_3738514040.webp)
4.4 Service mode
AUTO FORMAT ENABLED / DISABLED
(default ENABLED)
Auto format adjusts the picture to the best picture format and uses Black Bar
Detection for determination of the best format.
The picture format may always be selected manually using the Beo4.
ENABLED
Picture format is automatically adjusted for optimum format.
DISABLED
Picture format is maintained in the selected format.
The picture format is either the factory default setup or selected manually using
the Beo4.
FORMAT 4:3 ON/OFF (default OFF)
The picture format 4:3 is disabled in the factor setting.
It can be enabled manually using the Beo4.
4:3 is only enabled in FORMAT .
ON
Picture format 4:3 is enabled in FORMAT .
OFF
Picture format 4:3 is disabled in FORMAT .
CINEMA TIMINGS
Control the timings for switching from TV mode to Home Cinema mode and vice
versa.
Home Cinema is activated and de-activated by using ´FORMAT 0´.
HDTV DETECTION
Enabled: If a HDTV source is selected the TV will automatically switch between
CVBS input or Y/Pb/Pr input.
Disabled: If a HDTV source is selected the TV is always switched to Y/Pb/Pr input.
EXTRA BLANKING
Is used when a connected AV source requires a long blanking time.
CINEMA ON
Cinema Control and outputs can be used for controlling a motorised projector
screen, motorised curtains and light via expander boxes. For instance a motorised
projector screen can be connected to Cinema Control and light to Cinema
Control .
Both outputs are ´open collector´ and are not able to supply power to equipment
connected, which means that an external power supply is needed.
CINEMA CONTROL and
The setting decides the delay time of equipment connected and when ´Home
Cinema´ is activated the output is set to ´closed´ (low) after the delay time. This
means that the supply voltage, from the external power supply is connected to
ground by the ´open collector´. If for instance a relay for a motorised projector
screen is connected it will be switched and the projector screen will pull down. If
an expander box for other equipment is connected the input will be set ´low´.
Summary of Contents for BeoVision 7 MK II
