![background image](http://html1.mh-extra.com/html/bang-and-olufsen/beovision-7-mk-ii/beovision-7-mk-ii_service-manual_3738514041.webp)
Service mode 4.
CINEMA READY
The setting decides the delay from ´Home Cinema´ is activated until the projector
is warmed up and the picture is switched on.
STAND DONE
The setting decides the delay from ´Home Cinema´ is activated until the stand is in
standby position.
CINEMA OFF
Cinema Control and decides the delay time of equipment connected and
when ´Home Cinema´ is activated the output is set to ´open´ (high) after the delay
time. This means that the supply voltage, from the external power supply is
disconnected from ground by the ´open collector´.
If for instance a relay for a motorised projector screen is connected it will be
switched and the projector screen will pull up. If an expander box for other
equipment is connected the input will be set ´high´.
READY FOR CINEMA
The setting (00 sec.) decides the delay from ´Home Cinema´ is de-activated until
the projector has cooled down and can be switched on again.
TURN STAND DELAY
The setting (7 sec.) decides the delay from ´Home Cinema´ is de-activated until
the stand is turned into TV viewing position and the TV is switched on.
EXTRA BLANKING
It is possible to control the blanking time if for instance a Set Top Box connected is
slow to synchronize to a satellite channel.
The startup of the TV picture is delayed (blanked) according to the setting
belonging to the chosen input socket.
Summary of Contents for BeoVision 7 MK II
