The digital values for the IF variants in BeoVision 5 are the following:
B/G =
1
B/G/L/L’ =
3
B/G/D/K =
9
I =
16
B/G/L/L’/I =
19
M/I/D/K =
28
B/G/M/I/D/K = 29
Press
GO
to save the digital value.
AFC On/Off is used in connection with adjustments but it may also be useful in
other situations. Press
l
/
n
to move the cursor.
Press
m
/
p
to switch between On/Off.
AFC Off cannot be stored. AFC is always On after stand-by.
Chassis variant
- Chassis variant setup. In BeoVision 5 the line “Internal VCR” must always be set to No.
Remember to check the line if the EEPROM 6IC6 has been replaced.
Bus ignore mode
If an error occurs in the I²C bus system which makes the TV go into stand-by every
time it is attempted to be switched on, it is possible to switch on the TV in such a
way that the error is ignored:
- The TV must be on stand-by for at least 5 seconds.
- Short-circuit the service socket, P84 on AV Switch PCB14, coordinate 5L, for a
minimum of 0.5 second. See
➢
3.
- Remove the jumper.
- Press
TV
. The TV will now start up in the bus ignore mode if that is possible.
Service Mode, English 5.9
Summary of Contents for BeoVision 5
