Bang & Olufsen BeoVision 5, Manual

Page: 38 / 127

Video signal info
- In this menu the signal/noise ratio of the tuner input is displayed. The higher the
signal/noise ratio the lower the fi gure.
PIP HW correction
- Default set to OFF, but if there is a problem with the colours in the PIP picture it
can be set to ON (especially when mixing two TV systems, for example PAL and
SECAM).
Modulator system
When replacing the EEPROM 6IC6, PCB6 or PCB14 where PCB6 is mounted, the
modulator system must be set to the correct system BG or I.
TV-tuner
Select TV-tuner in the Service menu, press 2
In the TV service setup menu it is only the Tuner system and AFC fi elds that have
to be used. The rest of the fi elds are for factory usage, and the values in them
must not be changed.
Tuner system:
The digital value in the fi eld stands for the CTV system for which the applicable IF
is intended.
If the Tuner & IF PCB is replaced to permit reception of a different CTV system, the
digital value has to be changed.
The digital values for the various systems are the following:
B/G = 1
L/L’ = 2
M = 4
D/K = 8
I = 16
The digital value for system combinations is obtained by adding the applicable
digits.
Modulator system
System
BG
TV service setup
Tuner system AFC
1 On
Low tuning range High tuning range
45 860
Lower band limit Upper band limit
172 450
Vhf-1 const Vhf-2 const Uhf const
161 146 52
5.8 Service Mode, English