4.4 Service mode
Navigation
Beo4
Possible actions
MENU
Select menus
GO
- selects the submenu that a cursor is on
- accepts a menu, which results in values entered being saved
(in NVMEM) and the menu being exited
- activates functions, for example start/stop DVD
- deletes incorrect registrations in the monitor information menu
and exits the menu
m
Moves the cursor bar up
Returns to the previous menu when the cursor bar is at the top.
Modified data is not saved
p
Moves the cursor bar down
Selects a submenu in some cases
l
Modifies data
n
Modifies data
STOP
No interpretation
Digit
Modifies data
EXIT
Removes the menus
Service menu
This menu is used to select the device area in which service is to be carried out/
information is to be sought.
The contents of the menu depend on the sources installed.
Monitor service menu
Here you have access to the monitor’s underlying service menus.
Monitor information
If you select monitor information, the following is presented:
- SW version for application processor (indicated by PROM IC and module numbers).
- SW version for IOP (indicated by IC and module numbers).
- SW version for STB controller (indicated by IC and module numbers).
- SW version for STB controller’s table. The table is for the STB that it can control
(indicated by the IC and module numbers).
- Type number indicates country variant and the main group for the type approval.
- Item number; the device’s componentry and colours are described by means of the
number. The parameters for this include stand/front glass/colour/code converter/
country variant.
- The type number can be derived from an item number.
- Serial number (individual number), a unique number for this type of device.
- PIN-code status. The status indicates whether the master code was entered
correctly (STORED/NOT STORED).
- Current option setup.
- Last 5 TV errors (for example IIC bus errors), indicating the month and date.
- Last ML/SL error.
- In a product without physical ML HW, this status is NH (= No Hardware). See the
section on ML error codes.
- Last AVL status/error; this status describes the AVL link’s state in products with two
AVL links ( in each scart connector). Therefore there are two values for them. The
first value is for AVL in the VTAPE connector and the second value is for AVL in the
AV connector. The values can be seen in the section on AVL error codes.
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK
