International and national certifications
10.2 Certifications
Danger!
A complete system can only receive certification if all individual components installed and connected
in it have the corresponding certifications. If an individual component is used that does not have the
corresponding certification, the complete system will also not be certified.
B&R products and services comply with applicable standards. These are international standards from organizations
such as ISO, IEC and CENELEC, as well as national standards from organizations such as UL, CSA, FCC, VDE,
ÖVE, etc. We pay special attention to the reliability of our products in the industrial sector.
Information:
The certifications valid for the respective product are available on the website and in the user's manual
under the technical data in section "Certifications" or in the associated certificates.
10.2.1 UL certification
Ind. Cont. Eq.
E115267
Products with this mark are tested by Underwriters Laboratories and listed as "indus-
trial control equipment". The mark is valid for the USA and Canada and facilitates the
certification of your machines and systems in this economic area.
Underwriters Laboratories (UL) per standards UL 61010-1 and UL 61010-2-201
Canadian (CSA) standard per C22.2 No. 61010-1-12 and CSA C22.2 No.
61010-2-201:14
The UL certificates are available on the B&R website under
When using industrial control equipment per UL 61010-1 / UL 61010-2-201, make sure that the device is classified
as "open type". The prerequisite for certification or operation per UL 61010-1 / UL 61010-2-201 is therefore the
installation of the device in an appropriate protective housing.
10.2.2 EAC
Products with this mark are tested by an accredited test laboratory and permitted to
be imported into the Eurasian Customs Union (based on EU conformity).
10.2.3 KC
Products with this mark are tested by an accredited test laboratory and permitted to
be introduced into the Korean market (based on EU conformity).
10.2.4 RCM
Products with this mark are tested by an accredited test laboratory and certified by
the ACMA. The mark is valid for Australia/Oceania and facilitates the certification of
your machines and systems in this economic area (based on EU conformity).
Power Panel C80 User's manual V1.02
73
