Standards, guidelines and certifications
96
8JSA user's manual V1.00
Chapter 8 • Standards, guidelines and certifications
The motors are intended for use in commercial plants and subject to the following standards and guidelines:
Standards
EN 60034-1
Rotating electrical machines - Rating and performance
EN 60034-5
Degrees of protection provided by integral design of rotating electrical machines
EN 60529
Degrees of protection provided by enclosures
EN 61800-5-1
Safety requirements - Electrical, thermal and energy
UL 1004-1
Rotating electrical machines, general requirements
UL 1004-6
Servo and stepper motors
C22.2 no. 100-14
Motors and generators
Guidelines
Low Voltage Directive 2014/35/EU
The motors correspond to the low voltage directive (conformity).
EMC Directive 2014/30/EU
To operate the motor in accordance with its intended use, it must comply with the protection requirements of the
EMC directive. Proper installation (e.g. spatial separation of signal lines and power cables, shielded lines and
cables) is the responsibility of the plant installer and system provider. If operating with a power converter, then
the EMC guidelines of the power converter, encoder and brake manufacturers must be observed.
RoHS Directive 2011/65/EU
The motors in this series comply with the RoHS Directive (2011/65/EU) for the assessment of electrical and
electronic products with respect to the restriction of hazardous substances.
Note:
National, local and plant-specific regulations must also be taken into account!
Certifications
General information
8JSA
C-UR-US listed
Yes
UL file number
E61960