Installation • Configuring a SATA RAID set using the internal RAID controller
Chapter 3 Installation
Panel PC 900 User's Manual V1.05
163
7 Configuring a SATA RAID set using the internal RAID controller
The following software description applies to the internal RAID controller with QM77 chipset. The HM76 chipset
does not provide RAID support.
Information:
B&R recommends using only drives of the same type in a SATA RAID set (hard disk with hard disk in
a set, SSD with SSD in a set; CFast with CFast in a set).
Caution!
The maximum number of possible write cycles must be taken into consideration when setting up a
RAID set with SSDs (with MLC technology).
In order to create a SATA RAID set and get into the "Configuration Utility",
SATA mode selection
must be set to
RAID
in the "Advanced - SATA configuration" menu.
The "Configuration Utility" in BIOS must be started in order to make the necessary settings. After POST, pressing
<Ctrl+I> opens the RAID BIOS.
Figure 98: Configuration Utility - Boot
Figure 99: Configuration Utility - Overview