Power Panel 65 • 4PP065.0351-X74
30
Power Panel 65 User's manual V2.21
2.5.4 Diagnostic LEDs
There are four diagnostic LEDs on the back of the PP65.
Information:
The behavior of the Status LED has changed starting with AR J2.96, E3.01 and B3.06.
2.5.4.1 Diagnostic LEDs up to AR I2.96, D3.01 and A3.06
LED
Color
Status
Description
Red
On
Error/Reset
Status
Orange
On
Boot or Ready mode
User
Green
On/Off
LED operable by the user (with the AsHW library)
X2X
Orange
On
Module sending data via the X2X Link interface
CF
Orange
On
CompactFlash card being accessed
2.5.4.2 Diagnostic LEDs starting with AR J2.96, E3.01 and B3.06
LED
Color
Status
Description
Status
see following table "Status LED blink codes"
User
Green
On/Off
LED operable by the user (with the AsHW library)
X2X
Orange
On
Module sending data via the X2X Link interface
CF
Orange
On
CompactFlash card being accessed
Status LED blink codes
Blink codes (200 ms pattern)
Function
Error/Reset
No errors, normal operation
Battery not installed or battery capacity too low
CompactFlash media not found
Reserved for future blink codes
Because blink codes can only signal one error at a time, errors with higher priority take precedence. Fatal errors
have a higher priority than less significant errors (e.g. low battery capacity).
2.5.4.3 ACT / LNK LEDs for the RJ45 interface
There are two additional LEDs for the Ethernet interface.
ACT
(orange)
LNK
(green)
LED
Color
Status
Description
On
No Ethernet activity on the bus.
ACT
Orange
Blinking
Ethernet activity on the bus.
LNK
Green
On
Link established to the remote station
Summary of Contents for Power Panel 65
