Bandit
35
MODEL 15XPC CE
MAINTENANCE
WEEKLY MAINTENANCE
WHEEL LUG NUTS
ALL STEEL FRICTION AREAS
CHAIN DRIVEN COMPONENTS
Keep lug nuts tight, retorque, replace if needed.
Lubricate all steel friction areas including, but not
limited to pivoting, hinged, sliding, rotating areas on
the machine (i.e. stop bar, folding tray, discharge
flipper, hydraulic valves & linkages, height adjustable
discharge, discharge T-handle, etc.)
Use a dry lube on the hand crank swivel discharge
chain.
ALTERNATOR & FAN BELTS ON ENGINE
Inspect belt condition and replace as needed.
As applicable adjust and maintain per the engine
manufacturer’s manual.
MONTHLY MAINTENANCE
CHIPPER BEARINGS & CHIPPER SHEAVE
HYDRAULIC FUNCTION PRESSURES
DISCHARGE CHAIN TENSION
WHEEL BEARINGS
BRAKES
TOWING HITCH
DISCHARGE & INFEED HOPPER WEAR
SHARPNESS OF FEEDWHEEL TEETH
Check, retighten all bearing bolts, bearing lock
collars, and also belt sheave bushings to correct
torques.
Check, reset and maintain all hydraulic function
pressure settings to a maximum of the specified
pressure. This will give you the best performance
from the hydraulic system.
Check tension on hand crank swivel discharge
chain drive and tighten as necessary. Chain tension
is 6 mm (1/4”) per 0.3 m (12”) of center distance
between sprockets, NOT to exceed a 13 mm (1/2”)
of deflection.
Check and grease or oil wheel bearings per axle
manufacturer’s instructions.
Check and adjust brakes as needed per axle
manufacturer’s manual.
Check for excessive damage or wear. Replace if
needed. Keep pintle ring greased to reduce wear.
Check for wear on discharge, infeed hopper,
and discharge direction adjuster; build up, repair or
replace as needed.
Replace if needed.
3 MONTH MAINTENANCE
YEARLY MAINTENANCE
HYDRAULIC OIL FILTER(S)
HYDRAULIC OIL
FUEL TANK
HYDRAULIC SUCTION SCREEN(S)
Must be replaced after first 10 hours of operation,
use a 10 micron filter. After first change replace oil
filter every 3 months or 400 hours.
Change hydraulic oil and flush the hydraulic
reservoir tank.
Drain and clean the fuel tank yearly.
Change hydraulic suction screen(s) yearly or
every 2000 hours.
DISCHARGE SWIVEL PLATES
Grease swivel plates for discharge as needed.
Summary of Contents for INTIMIDATOR 15XPC
