P. 19 - Control Box mounting
Control Box
Control box
PCB 6 p plug-in
connector
R
e
d
W
h
it
e
G
re
e
n
B
lu
e
Y
e
llo
w
B
la
c
k
BANDIT
240 Control Box
3
H
Y-
test
BANDIT
main PCB
82 mm
27 mm
1
1
2
m
m
Side housing
alarm central
nut M4
inner side of
alarm central
12 metres
connecting cable
HY-3 pack level / niveau / livello
90
60
30
0%
BANDIT
240 DB
v.206
test
tech out
OK
The "Control Box" is the most used and requested
option which comes with the
BANDIT
240DB. It
permits the installer to easily perform unit tests
during the annual inspection and easily open the
side hatch in order to change the HY-3 pack
Installation:
The box has to be installed in an access secured
housing. Normally the "Control Box" is installed in the
housing of an existing alarm panel. The required screws
and nuts are delivered with the box. The box cannot be
opened, the inner electronics and connecting wire are
sealed within. The sealed in connecting wire has a
standard length of 12 metres. If it should be too short to
reach the
BANDIT
, it can be
extended with a max. of 100
metres, using a standard
6 way alarm wire.
Normally connect colour to
colour
(best separately soldered)
and insulated and finished with
a general insulation over the
complete wire. In the packing
of the “Control Box” you’ll find
the mounting screws and
nuts, also a 6 way plug-in
connector with screw connection.
First insert the connecting wire through the input
swivel of the unit. Then strip the strands and connect
to colours identified on the plug.
If explicitly requested
while ordering, the
"Control Box" can be
delivered with
requested length of
the connecting wire
(max 100 meter) and
wire colour (white or
brown). Each extra
meter wire is charged
with 1.71 € + VAT
Slide the male plug on to the 6 way female
connector on the PCB (see p 9, PCB lay-out to locate
control plug-in connector). Switch dip B3 to OFF (0)
and push the read switch (read = update with
dipswitch adjustments).
The wire and signal strains are sabotage secured through
the unit.
Consider well while installing that the person who has access to
the "Control Box", also is in control of the functioning of the
BANDIT
fog generator.
If it is not possible to mount the "Control Box" within the inner housing
of an existing alarm installation, you’ll have to install the "Control Box"
in a key and sabotage secured metal box, in a location which can’t be
reached without being detected from at least one burglary detector.
For exact functions of the different switches and LED-bar, see next
page
.
