10 |
System overview |
H5000 Operation Manual
Analog displays
Before a value will be shown on an analog display ensure that a sensor (source) has been
selected via the CPU or Graphic Display. Go to source selection to achieve this.
The analog display backlighting is achieved by a long press of the
MENU
key on any of the
Graphic displays.
There is a wide range of analog indicators available, all listed below.
• Apparent Wind Angle
• Apparent Wind Speed
• Boat Speed 12.5 Knot
• Boat Speed 25 Knot
• Depth 200 Meters
• Depth Ft / Fathom
• Heading
• Rudder
• True Wind Angle
• True Wind Speed
• Magnifi ed Apparent Wind
Expansion modules
There are two types of Expansion module, Analog and Serial. The modules act as the interface
between analog sensors, serial devices and other in and outputs to and from the CPU.
The correct module must be used in conjunction with its corresponding sensors. All modules
are powered from the network and can supply power to the sensors connected.
Analog
The analog module has 6 analog inputs and 2 pulse inputs. This allows the unit to act as an
interface for masthead units, speed sensor, analog rate-gyros, potentiometer etc.
Serial
The serial module has 2 COM ports, each with input & output. The modules support RS232,
RS422, RS485 and NMEA 0183 devices.
Modules can be located wherever is most convenient for the installer and can connect
anywhere on the network.
