![background image](http://html1.mh-extra.com/html/bandelin/sonorex-ze-1031/sonorex-ze-1031_operating-manual_3852433022.webp)
6
/
Maintenance
22/36
6486-001 GB/2021-04
6 Maintenance
6.1 Cleaning and care of the ultrasonic bath
Cleaning the ultrasonic generator housing
• Damp wipe the housing. Wipe it dry with a soft cloth.
• Do not use any abrasive cleaning products, only care products without scour-
ing additives.
• If necessary, disinfect the housing with a suitable surface disinfectant.
Care of the ultrasonic oscillating tank
Impurities in the ultrasonic oscillating tank accelerate its wear, can lead to corro-
sion and reduce the ultrasonic effect. Therefore, observe the following instruc-
tions:
• Rinse the ultrasonic oscillating tank thoroughly with water after each use.
Wipe it dry with a soft cloth.
• You can remove marks and residues with a stainless steel cleaning product
without scouring additives.
• Do not use steel wool or scrapers to clean the ultrasonic oscillating tank.
• Metal parts and rust particles in the ultrasonic oscillating tank cause corro-
sion. Therefore, do not leave any metal parts in the ultrasonic oscillating tank.
If rust marks are visible, remove them immediately with a soft cloth and a
stainless steel cleaning product without scouring additive.
6.2 Checks
NOTICE
Damage to the ultrasonic bath
– Perform checks only on the filled ultrasonic bath.
If one of the checks does not lead to the desired result, contact our service
department. See chapter
6.4 Repair
.
Checking indicator lamp – ST 15.1
Check the function of the indicator lamp.
• Switch the ultrasound on briefly.
– The green indicator lamp lights up as long as the ultrasound is switched on.
Checking indicator lamps – ST 30 DT
Requirement
• The ultrasonic bath is switched off.