6486-001 GB/2021-04
17/36
Operation
/5
NOTICE
If you use an agent in powder form, do not pour it directly into the ultrasonic
oscillating tank.
– Mix agents in powder form in another container before you pour them into the
ultrasonic oscillating tank.
– Only pour the agent into the ultrasonic oscillating tank once it has dissolved
completely.
Fig. 4
Overview of ultrasonic bath
1 oscillating tank
2 Filling level mark
3 Operation (depending on model; control panel ST 15.1 or control panel ST 30 DT)
4 Ultrasonic generator
5 Drain (optional; here Viega fitting)
Requirements
• On ultrasonic baths with a drain, the drain must be closed.
• The ultrasound must be switched off.
Procedure for direct sonication
1. Fill the ultrasonic oscillating tank with water up to
1
⁄
3
.
2. Pour the correct quantity of agent for the sonication fluid into the oscillating
tank. See chapter
9 Dosing table
.
3. Fill the tank with water up to the filling level mark while avoiding foam forma-
tion.
Procedure for indirect sonication
1. Fill the ultrasonic oscillating tank with water up to
1
⁄
4
.
2. Pour the correct quantity of agent for the sonication fluid into the oscillating
tank. See also information for insert tub.
3. Fill with water, see also information for insert tub. Take the displacement
caused by the insert tub into consideration. Also avoid the formation of foam.